Kwikset Door Lock Beeping After Opening

Why is my kevo smart lock beeping.

Kwikset door lock beeping after opening. Make sure the mastercode has not already been programmed. It will also beep if there is a warning such as a low battery or a jammed bolt. Make sure you lock is installed on your door and that your door is all the way open. To turn the beeping sound off.

It will also beep if there is a warning such as a low battery or a jammed bolt. Make sure switch 3 is on. The door handing process was not executed during installation. Here are the instructions for the door handing.

Ensure your door cannot close on its own or that you have another way to enter you home. If you have a deadbolt make sure it is in the locked potion. On my smartcode 909 910 the lock beeps the keypad flashes red and the door cannot lock. Use a fresh set of batteries and perform the door handing process.

Move the third switch from the left it has a speaker icon above it to the off downward position. There are a few types of electronic locks made by kwikset. Ensure door preparation is in accordance with the door drilling instructions available online 4. Move the third switch from the left it has a speaker icon above it to the off downward position.

Reinstall the battery cover. If the latch does not extend or retract and the lock does not beep press each individual key on the keypad one at a time. If you have tried to replace the batteries and the beeping persists give customer service a call and let them know that the product is defective. If you have a knob or lever make sure it is in the locked position.

If you hear three beeps andnote. Make sure the turnpiece is in the vertical position. Most likely you either have the powerbolt or smartcode. Wait for the led on the interior side of the unit flashes and the unit emits a beep indicating successful bolt operation programming before further operation of the lock.

The keypad is unresponsive. Remove the battery cover. The lock should beep twice when it unlocks and once when it locks. The lock should beep twice when it unlocks and once when it locks.

Make sure switch 3 is on and press the program button once. To turn the beeping sound off. Remove the battery cover. Step 2 realign the door if the bolt does not operate smoothly when opening with a key.

Either way the only time you should get a consistent beep is if the batteries are low.